Click image to view full size image
Automatic Rubber Vulcanizing press
OPERATION DESIGN
1.One operator can handle multi stations to save labor cost.
2.Auto sliding devices at moving mold plates make operation easy; even female workers can operate the machine.
3.Auto inter-lock protection system for two-side simultaneous working assures safety of operation.
4.Mold change is simple and fast just by fixing bottom mold plate at sliding seat.
5.Every station is with independent operating control. Each station can be switched on/of according to production or maintenance schedules, in the meantime, to save power consumption.
6.According to the production necessary it can flexible connect stations, max. 6 stations use one system.
Auto sliding in/out and inside-tuming design for molds
HIGH PRODUCTIVITY
Every station two molds with two-side operation
MOLD FOR PRODUCTION
1.Traditional hot-compressed rubber molds can be utilized on the machine.
2.Clamping system is with direct hydraulic press; molds with different height can be adopted directly.
3.Automatic sliding devices for mold opening / closing is equipped to avoid mold damage caused by collision and to minimize cost of manpower.
The machine form: Column or Frame
Technical parameter
1.type.................................XLB-DQ450x450MM
2. total pressure..................................1.50MN
3. plate size...................................450x450mm
4. plate clearance.................................180MM
6. working layer number................................2
7. piston stroke................................360mm
9. Piston diameter.................................300mm
12. Electric heated platens
13.Rough degree of hot plate surface : Ra ≤ 1.6 μ m (surface finish)
14.Material: #45 grade steel (1045)
15.Platen is one piece plate steel (no welding)
16.Piston (ram) hardness : 68-72 Shore C
18. Electric : Siemens and Schneider
19. Working Temperature: 180 --200